Heavy duty 3mm steel seat plate covered with high-quality contouring foam.
Non-adjustable center seat gap. (See the Salli SwingFit for adjustable seat width and center opening.)
Top-quality upholstery meets California TB 117 flammability standards. Available in premium leather. Synthetic suede, polyurethane, ESD leather, and ESD fabric are also available by special order.
Large 65mm casters for easy maneuverability on carpet or hard floors. Optional deep pile, braking, locking, cleanable (barber) and industrial casters also available.
Meets CA TB 133 flammability standards.
Manufactured in Finland.
Leather, artificial leather, ESD fabric/artificial leather, see colour chart
Hand controlled height adjustment with gas spring
Gas spring and base metallic or black
Weight 11 kg
Warranty 10 years
Short - for users < 165cm
Medium - for users between 160cm - 185cm
Tall - for users over 175cm
Footring - Short lift
Footring - Medium lift
Footring - Tall lift
Hand/foot control - Short lift
Hand/foot control - Medium lift
Hand/foot control - Tall lift
21.26" Standard Aluminium
23.62" Large Aluminum
27.56" Extra large Aluminum
65mm Standard Casters - Carpet (Hard)
65mm Standard Casters - Floor (Soft)
50mm Locks when loaded - Hard
62mm leanable (Openable) - Hard
65 mm Locks when unloaded - Soft
65mm Mechanically lockable - Soft
65mm Coloured Casters (red, blue, green, orange, metallic) - Soft
75mm Industrial - Soft
75mm Industrial - Hard
SKU: 3ss-TOOL - Disaembly tools
SKU: 4600-20 - Footring 20"
SKU: 4Ss-B-STR - Slip cover, Classic cotton
SKU: SS1-SC1-FIRE - Slip cover, Classic, fire block
SKU: SS1-SC1-H20 - Slip cover, Classic, water resist
SKU: SS1-SC1-LEA - Slip cover, Classic, leather
SKU: SS1-SC1-UL - Slip cover, Classic, Ultraleather
SKU: SS1-SC2-COT - Slip cover, Twin, cotton
SKU: SS1-SC2-FIRE - Slip cover, Twin, fire block
SKU: SS1-SC2-H20 - Slip cover, Twin, water resist
SKU: SS1-SC2-LEA - Slip cover, Twin, leather
SKU: SS1-SC2-UL - Slip cover, Twin, Ultraleather
SKU: SS1-A-EGR-R - Ergorest mobile arm, right side only
SKU: SS1-A-EGR-2 - Ergorest mobile arms, pair
SKU: SS1-A-EGR-2P - Ergorest mobile arms, pair w/ back
SKU: SS1-A-AR - Allround Arm
SKU: SS1-A-ELR - Elbow Rest ("Small Elbow Table")
SKU: SS1-A-ELT - Elbow Table w/ pads ("Big Elbow Table")
SKU: SS1-A-ELSBR - Elbow Support + Backrest for Salli Surgeon
SKU: SS1/HANDLE - Seat handle
When sitting on a saddle chair the spine is almost in the same position as when standing: there is a small curve in the lower back and the vertebrae is not pressing the disks. This position is natural and therefore easy to maintain. Sitting on a saddle chair reduces tensions in the back and sciatic-type pains, enhances circulation, makes breathing deeper, keeps the hip joint in the optimal 135 degree angle and makes it easy to move around on the chair. The two-part seat does not press the genital area, which is beneficial to genital health. More information on the effects of riding-like sitting below.
In riding-like sitting the posture of the back is automatically correct and therefore there is no need for a backrest. The pelvis is in the correct position, which makes keeping the back upright as easy as if we were standing or walking; we do not need any backrest when we are standing either. In a chair with a backrest the thighs and upper body form a steep 90-degree angle, which makes the pelvis tilt backwards. Then the back becomes rounded, the position makes the back tired, and that makes us lean on the table and round the back even more.
Yes, on a two-part saddle chair you can. In the riding-like sitting position you feel good and energetic, both at work and in leisure. On a saddle chair it is possible to tilt the pelvis forward, which makes a natural curve in the lower back. Because of the gap the chair does not press the genital area, and thus there is no need to tilt the pelvis back, away from the pressure. Tilting the pelvis back makes the back round, which is very harmful for the disks and the overall health of the lower back.
The sitting position differs a lot from that on a traditional chair. Instead of being passive the muscles work actively. You may have sore muscles and tissues after starting a new sports; the same happens when you start sitting in the new way. The sitting bones carry the weight of the upper body, and that may make the buttocks feel sore. Some people get used to the new sitting position in days; for others it may take months.
If the chair feels hard around the sitting bones it may be too high for you. Then the whole weight of the upper body is on the sitting bones. It is best to sit with feet firmly on the ground because then the feet carry part of the weight. Be aware of not adjusting the chair too low, as then you may tilt your pelvis backwards and that rounds the back into a bad position. The chair may also feel hard if you sit too far front. Your buttocks should be right at the edge of the chair. Then you can tilt the pelvis forward, which improves your position. If you work in front of a table for long periods of time the table should have a socket. That enables you to keep the arms close to the body, and part of the weight of the upper body to rest on elbows.
The patented gap enables you to tilt the pelvis into the natural standing posture without feeling pressure in the genital area. On a one-part saddle chair the sitter often moves the feet forward to reduce pressure and warmth on the genital area, and ends up with a rounded back. In addition to the chair being more comfortable to sit on, the gap improves the genital health of both genders through improved circulation and nerve functions. The gap also makes the chair cool and well ventilated.
On Salli you sit 15–20 cm higher than on a traditional chair. The natural curve is possible when both the knee angle and the angle between the thighs and the body is 135 degrees, and that happens automatically in riding-like sitting. We highly recommend an electrically adjustable table, or at least a table that is higher than normal, to be used with Salli Saddle Chairs. Only then can you fully benefit from the chair. An electrically adjustable table can be individually adjusted for sitting and standing, reading and writing, and according to the times of the day.
The mechanism cannot be locked into a specific position. The active seat follows the movements of the body and activates the deep back muscles. The swing is not as mobile as one could imagine and it does not move by itself; it only follows your movements.
On the active chairs you sit a bit lower than on other models, because the feet need to be firmly on the ground and the knees need to be elastic. If you are sitting too high the chair feels shaky. It is advisable to get used to the chair by sitting quite a bit lower than you would normally sit on a saddle chair. When you get used to the movement you can adjust the chair a little higher.
Salli Swing and Salli SwingFit come with a tool that can be used to adjust the stiffness of the mechanism. It can also be adjusted with a 24 mm wrench. See how to adjust the swing mechanism.
In a two-part seat, the leather upholstery should not make you sweat. When sitting on a one-part chair the air cannot circulate under the buttocks and that makes one sweat. To avoid this, one tends to change the position constantly and often ends up in a position that is bad for the back. The chair can also be made of artificial leather, or you can buy a cotton seat cover from our selection. The seat can also be upholstered with a fabric of your own, as long as the fabric is durable enough. An old chair can be re-upholstered; deliver the chair to your dealer for re-upholstering. See instructions for taking care of your Salli.
Congratulations on your choice! You do not need tools to assemble the chair. The chair has only three parts and is very easy to assemble. You received an instruction manual with your chair; please read it carefully. If you got your chair in winter let the gas cylinder warm to room temperature before assembling the chair.
The castors do get worn out in time. Often sand and dust between the floor and the castors wear them and cause the chair not to move easily. We recommend that you change the castors every five years to keep the chair rolling. Castors are available from your local Salli dealer.
If the adjustment mechanism is tight, rap it briskly with your palm a couple of times. Strike towards right when looking from behind the chair. When you lock the width, the lever does not need to be pressed tightly into the ultimate position; it is ok when it catches and the parts of the seat remain in place. Do not press the seat parts together with your thighs when the lever is locked because that may cause it to lock too tightly. Always get up from the chair to adjust the width.
A tight skirt prevents you from sitting in the healthy riding-like position where the thighs should be in a 90 degree angle in relation to each other. A loose and stretchy skirt or a wraparound skirt facilitate the position in which it is possible to maintain good posture and a good feeling all day long. Clothes that are too tight are not recommended in sedentary work because they weaken circulation.
Men should definitely use the two-part Salli chairs. Because of the middle gap the chair does not press the genital area and therefore the circulation and nerve functions of the area are not disturbed. On a two-part chair men can also tilt the pelvis forward to create the curve in the lower back that enables good posture. In Salli SwingFit and Salli MultiAdjuster, the width of the gap is adjustable.
Time makes even good positions poisonous, so the magic word is change: change your position, make use of the active seat of Swing models and work standing for a while. Test height, inclination and width adjustments to find the best ones for you. We cannot stand for hours on end in exactly the same position, and the same goes for sitting. What the body needs is movement. It may also be that it takes you a bit longer time to get used to the chair – do not give up!
Yes, we have a wide selection of spare parts and accessories. Please contact your local dealer for spare parts.
The following observations describe impacts that are achieved only by sitting on an active, two-part saddle chair. Sitting on the traditional one-part saddle chair contains so many serious problems in connection with posture, genital health and also with the health of the inner pelvic organs that it cannot be recommended as a working chair.
Riding-like sitting is fundamentally different from the traditional sitting. The change affects positively the whole body, circulation and metabolism. Minimizing the disturbances in metabolism and eliminating health risks are the major goals of ergonomics.
The most essential positive effects of riding-like sitting are focused on the spine, all the way from lower back to the cervical vertebrae. Riding-like sitting affects posture, circulation into the lower limbs, genitalia, external and internal pelvic organs, muscles and joints, bowel movement, breathing, circulation into the head, and the alertness of the brain and the eyes.
Riding-like sitting makes it possible to improve vital functions by exercising, reaching from the chair and tilting the seat. These movements make sitting more active and improve work conditions.
When people start improving their sitting radically, the effort alone brings about a change in them. New kind of sitting makes people more conscious of their circulation, muscle tensions, back health, posture, metabolism and sitting position, and makes them want to improve their sitting environment further.
The statements on these pages are based on the following sources:
Michael Adams, Nikolai Bogduk, Kim Burton, Patricia Dolan: The Biomechanics of Back Pain
David A. Rubenstein, Wei Yin, Mary D. Frame: Biofluid Mechanics, an Introduction to Fluid Mechanics, Macrocirculation, and Microcirculation
Marcus J. Seibel, Simon P. Robins, John P. Bilezikian: Dynamics of Bone and Cartilage Metabolism, Principles and Clinical Applications
Special Order: This is not a stock item and is ordered specifically for you. Unfortunately, no returns, no cancellation, so please call our trained staff with any questions you may have prior to ordering to ensure you make a well informed, educated purchase. This sale is final.