Your cart is currently empty |
Subtotal: | $0.00 |
All accessories can be purchased separately
Dimensions: 4.9” L x 2.0” W x 1.0” H. (124mm x 51mm x 25mm) (Not including clip or microphone assembly)
Weight: 3.1 oz. (88 grams) (with batteries)
Color/material: White ABS/Polycarbonate molded plastic case.
*Battery Type: Two (AAA size), either 1.5 VDC Alkaline* or 1.2 VDC NiMH rechargeable* (Williams Sound BAT 010-2 Alkaline or BAT 022-2 NiMH)
Battery Life: Up to 105 hours (typical usage) with the BAT 010-2 (Alkaline).
Low Battery Indicator: Power “On” Green light on front panel flashes.
Microphone: Internal, omnidirectional MEMS microphone (micro-electro-mechanical system).
Optional External, omnidirectional, plug-in electret microphone with foam windscreen and 3.5mm mono plug (MIC 014-R).
T-Coil: Internal with on/off switch and LED indicator.
Tone Control: External rotary control knob allows user to adjust high/low frequency to optimize hearing.
***Balance Control: Adjusts Left/Right Volume Balance
Power/Volume Control: External rotary volume control knob with integrated power ON-OFF switch.
Microphone Jack: 3.5 mm, stereo mini plug. Tip=Mic signal, Ring=NC, Sleeve=Gnd.
Headphone Jack: 3.5 mm, stereo mini plug. Tip=Left/Mono, Ring=Right, Sleeve=Gnd.
Charging Kits: BAT KT8 (International)
Approvals: CE (Note 1), RoHS2 (Note 2), FCC, IC, WEEE (Note 3)
Warranty: 5 years, parts and labor (90 days on accessories)
Electrical Specifications (1 kHz Sine Wave reference) Typical
Power Output: 52 mW (max) into 32 ohms (Stereo)
ALC: Automatic Level Control; Limits maximum output level
Distortion: 1% THD (max)
Max Gain: 63 dB @ 2.5 kHz (Tone=High)
Operational Temperature: 41°F to 104°F (5°C to 40°C)
Charging: 16 hours with BAT 022-2. Red LED blinks when charging.
End of Charge: Red LED is on solid. At end of charge, maintenance charge is provided.
NOTE: Charging requires optional charging kit BAT KT8.
Tone Control At High Position: 2.7dB boost at 5 kHz, 6.7dB cut at 400 Hz.
Tone Control At Mid Position: 0.6dB cut at 5 kHz, 2.9dB cut at 400 Hz.
Tone Control At Low Position: 2.0dB cut at 5 kHz, 3.0dB boost at 400 Hz.
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
*Battery switch must be in correct position for battery type being used.
**Charging requires optional charging kit BAT KT8 (International).
***When using mono earphones, headphones or neckloop, the balance control on the Pocketalker must be turned fully counter-clockwise (to the “mono” position) for best volume and battery life.
The Pocketalker is not sold, advertised, or intended for use as a personal hearing aid. Williams Sound recommends that any individual experiencing hearing loss be examined by a physician/audiologist to determine the cause before using an amplification device such as the Pocketalker.
Acoustic Specifications for Headphones recommended for use with the Pocketalker are published on our website.
Note 1: CE approval does not apply if product does not display the CE mark.
Note 2: RoHS2: Directive 2011/65/EU
Note 3: WEEE: Directive 2012/19/EU
This product is covered by the European directives above, including amendments, concerning Waste Electrical and Electronic Equipment (WEEE). Recycle the product and its accessories according to national regulations.
Style: Dual, in-ear, isolation earphones
Plug: 3.5mm stereo
Cord: 39"
Driver Size: 10 mm
Nominal Impedance: 32Ω
Freq. Response: 20 - 20kHz
Weight: 10g
Max Power Input: 5 mW
Sensitivity: 104 dB @ 1kHz
Replacement Silicone Tips: EAR 043 (0ne pair)
Style: Stereo Headphones
Plug: 3.5mm stereo
Cord: 39"
Driver Size: 30 mm
Nominal Impedance: 16Ω
Freq. Response: 20 - 20kHz
Weight: 60g
Max Power Input: 100 mW
Sensitivity: 108 dB @ 1kHz
Replacement Pads: HED 023 (one pair)
Phantom Powered: No
Pick-Up Pattern: Omni-directional
Element: Electret Condenser
Mic Diameter: 10 mm not including windscreen 19 mm with windscreen
Sensitivity: -42 dB ± 3 dB
Frequency Range: 20 Hz - 16 kHz
Output Impedance: 2.2 kΩ
Standard Operation Range: 2 - 10 V DC
Signal-to-Noise Ratio: [gt]58 dB
Replacement Windscreen: WND 002
Optional 12 ft Extension Cord: WCA 007
Optional Microphone Clip: CLP 014
Color: Gold
Weight: 5 g (0.2 oz)
Plug: 3.5 mm mono
Cord: None
Approvals: RoHS
Warranty: 90 days
Pocketalker 2.0 Specifications
Pocketalker 2.0 Manual
Pocketalker Brochure
Pocketalker Cleaning Instructions
Pocketalker Comparison Chart
Warranty
5 Years
SKU: PKT 2.0 US
Please fill out the form below to request a product quote. A representative will respond to you via email or phone as soon as possible.